FIGURE 5.
Programming a MultiStar ESC
The MultiStar ESCs are a little easier to program. You
simply set the jumpers on the card as shown in Figure 5.
Plug the ESC cable into the card as shown, then attach the
battery and wait for the motor to beep. Then, remove the
battery and move to the next ESC.
Calibrating the ESCs
Calibrating the ESCs is very easy. Please note that
you should not have the props attached when you are
doing this.
First, plug the ESC cable into the out jack on the servo
tester. Be sure to observe the polarity of the cable. Move
the knob on the tester fully clockwise (max) as shown in
Motor Setup
Don't put your servo tester away just yet. You need to use it to test the direction of your motors. Connect the servo
tester to ESC #1 using Figure 8 as a reference. Make sure the servo tester is adjusted so that it is at its minimum setting
(full CCW). Attach the battery.
FIGURE 8.
56 SERVO 02.2013