Slip the battery into the space shown in Figure 20.
The main power and balance leads should be positioned
on the upper left of the battery as shown.
Before attaching the battery, make sure your radio is
turned on and that the throttle (channel 3) is in the full
down (off) position.
38 SERVO 02.2014
Figure 20. Figure 21.
Attaching the Front Cover
Start by attaching trimmer line to the trimmer line head. To
do this, insert the line into one of the holes through the top of
the head, then back up through an adjacent hole as shown in
Figure 17. Start with about six inches of line on each side. Be
sure you mount the line directly opposite from one another as
Insert two #6-32 x 3/8” nylon machine screws into the two
tabs on the center of the craft. Leave about 1/8” space
between the head and the tab. Next, slip the front
cover/weapon assembly under the two screws as shown in
Secure the front cover with four more screws as shown in
Figure 19. Note that the screws should be tightened until they
are snug. Don’t over-tighten or you can break the tab.