just to make sure it engages the jaw on both ends.
Our indicator engages the jaw through the complete
width of the vise. Make sure the indicator is on the left end
of the jaw; slightly tighten the left nut on the vise as shown
in Figure 13. Don’t make it so tight you won’t be able to
rock the opposite end of the vise for adjustments. Next,
zero the indicator by rotating the bezel until the needle
reads zero (Figure 14).
Move the table so that the indicator is on the right side
of the jaw as shown in Figure 15. Be sure not to move the
Y axis as this will throw off your adjustments. The reading
shown on the indicator shows the degree of misalignment.
Move the vise with your hand until the indicator reads zero
as shown in Figure 16.
Once you are happy with the new position of the vise,
58 SERVO 06.2015
Figure 15. Figure 16.