25.
Pop in a double angled
studless beam and a
five-hole studless beam
on either side of the
NXT as shown.
26.
27.
Snap in two friction pins on each side of
the assembly, and grab an NXT (note: This
model is designed for use with AAs- not
the rechargeable battery). Snap a blue
hybrid axle-pin to either side of the NXT.
Snap in three standard friction pins and
one double friction pin on each side of
the robot.
Add a 5 x 3 angled
studless beam, a
friction pin, and a
double friction pin
on both sides of
the robot.
28.
Snap in two double
friction pins and a
double angled
studless beam to —
you guessed it — both
sides of the robot!
29.
Secure the
double angled
studless beams
with 5 x 3 angled
studless beams.
30.
Slide blue hybrid
axle pins into the
double angled
studless beams, and
snap in friction pins
as shown.
31.
32.
Attach 5 x 3 angled
studless beams to
your pins, then add
two friction pins to
each one.
Snap 11-hole studless beams into your
pins on either side. These will allow
Chariot to run your opponents off of a
raise ring without falling out itself!
33.
34.
Slide in a four-stud
axle on each side of
the robot.
SERVO 04.2012 71