Step 4
Using a 9/64" drill bit, widen the
four mounting holes in the power
distribution board. Remove the rubber
backing from it.
Using four #6-32 x 1.5" machine
screws, attach the power distribution
board to the platforms as shown in
Figure 7. Notice there is a set of #6
washers between the power board
and the upper platform.
FIGURE 6.
FIGURE 7.
FIGURE 10.
these nuts, as you make break the
corners off the platform.
Warning!!! Don't use red thread
lock or you won't be able to remove
the nuts later!
Step 8
Using two #6-32 x 1" machine
screws and washers, attach a motor
assembly to the end of each boom as
shown in Figure 10. Secure with a
washer and #6-32 hex nut. Add a
drop of thread lock to each nut and
tighten with a wrench. Be sure the
wires are facing the center of the
craft.
Step 9
Use two eight inch tie wraps to
mount the ESC to the platform as
shown in Figure 11. Use the two 1/4"
holes in the platform to thread the tie
wraps. The two battery leads should
be plugged into the power
distribution board. Plug the red lead
into the red plug. Plug the black lead
into the black plug. Leave the three
motor leads unconnected at this time.
FIGURE 11.
FIGURE 12.
SERVO 01.2013 61