Wheels
The six wheels shown in Figure 1 consist of three
parts each:
• Wheel Hub Cap
• Wheel Geared Hub
• Wheel Tire
Wheel Hub Cap
The hub cap shown in Figure 2 is a 3D printed part. It
consists of three posts that are meant to insert into
mounting holes in the wheel tire. The holes in the posts are
.089” in diameter and should be tapped with a #4-40 tap.
The overall diameter is 1.7”, so you should be able to print
four or more on most 3D printers. If you are printing in
PLA, it is highly recommended that you print at least three
wheels to keep the posts from overheating and melting.
Wheel Geared Hub
The geared hub shown in Figure 3 is driven by either
the motor or idler gears. It is attached to the hub cap and
tire assembly via four #4-40 x 3/8” machine screws. While
you can print more than one of these at a time, it is
recommended that you print only one at a time to keep the
gear as accurate and clean as possible.
This time, I’ll go over the wheels,
gears, and chassis parts for our
Plastic Bot of Descruction (PBOD).
The STL drawing files for the printed
parts are available on the Kronos
Robotics website. I will list links
later in the article.
By Michael Simpson
54 SERVO 12.2013
Post comments on this
article and find any
associated files and/or
downloads at www.servo
magazine.com/index.php/
magazine/article/december
2013_Simpson.
Part2
Build the Plastic
Bot of Destruction
Figure 1.